I still don't completely understand what I did, but it gave me a reason to repeat the process. It may be because I hit Restart during my live session on the school computer and when it shutdown I pulled out my usb, THEN opened it again on my Acer. The last step required a restart, and when I did I could not longer access wireless. I did find out that once I got my wireless up and running all was fine.then I slipped my usb into a school computer and booted up my system, installed some software, updated and upgraded. This is my second run through of the procedure, just to make sure that I can successfully repeat the results. I want to use my new live system on desktops primarily, but I also use it on my Acer D250 netbook, which requires an updated wireless driver anytime I install a new system. If all goes well, you should now have a larger casper-rw loop file to use for saving your persistent changes. Type the following into the terminal window and press enter.Open a terminal and change directory (CD) to the location of your casper-rw file.After you're up and running in Linux, insert the flash drive that contains your casper-rw loop file.You should create a backup just in case before proceeding. The following method will allow you to resize your existing casper-rw image(expand casper-rw). 8Also, be patient because the two commands below may take a few minutes: Remember that I set 'space across reboots' at 128mb. I'll go ahead and say that I set my size to _, which combined with the actual iso was almost a perfect fit in my 4GB partition (the one that I shrank). Menu label ^Try Ubuntu without installingĪppend initrd=/casper/initrd.lz file=/cdrom/preseed/ed boot=casper quiet splash - persistentĪppend initrd=/casper/initrd.lz file=/cdrom/preseed/ed boot=casper only-ubiquity quiet splash - persistentįollowed instructions for Resize an existing casper-rw loop file, seen below. Menu label Boot into Ubuntu 12.04 LTS *persistent*Īppend initrd=/ubninit file=/cdrom/preseed/ed boot=casper quiet splash - persistent I had roughly 10GB left.įollowed procedure listed by Sudodus to make sure everything was behaving correctly. The remaining space I formatted to fat32, both as external storage and to still use this usb as a flash drive. Using Gparted, I created a 1GB Linux Swap partition. From what I understand, once the iso partition is shrunk, you can always replace it with a different iso. I'm using a 16GB usb 3.0 drive (3.0 is faster, so it is a better option for a persistent install), so I resized my partition to 4GB, knowing that I would resize my casper-rw file within that space. Reboot to check that all is well and the USB drive runs a live session Set 'space across reboots' at minimum of 128 (to be resized later). My procedure was to use Disk Utility to format my drive MBR, then format it to FAT. Hope this helps someone!įormat to FAT/FAT32 with Disk Utility, Gparted, or similar. I'm assuming this works using uNetbootin on Windows, though I did this through Ubuntu and Lubuntu 12.04 to create a working Persistent install. This method worked like a charm for me, and I don't think it's too technical. I've been using Ubuntu and Lubuntu for a few years now and have very little formal technical training, but I finally feel like I might be able to contribute to the community.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |